It is possible to enter the length of a line by using a custom keypad.
In Add new lines mode, tap on the screen to create a line in the desired direction. Pan with your finger to ensure that the line is vertical, horizontal or at 45 degrees.
Once the line has been added the length can then be entered.
In Edit Line mode, select the line to be edited and then enter the desired length using the keypad.
The screenshot below shows the Icons to
- Toggle the Interface left/right
- Display Help Videos
- Delete digits
- Clear the length field
- Confirm the Line length
- Edit to Previous line
- Edit to Next line
The following toolbar Icons are available when Adding Lines
- Expand Scale
- Shrink Scale
- Swap Active Node
- Zoom into current line
- Toggle Snap To On/Off
- Remove current Line
The following toolbar Icons are available Editing Lines
- Expand Scale
- Shrink Scale
- Swap Active Node
- Magnify the current line and position it in the view.
- Toggle the "Snap To" feature On/Off
- Reverse order of lines
Switching to other Rulers
The 3 buttons at the bottom allow the user to switch to the Tape Measure Ruler, Angle Ruler or Run Rise Rulers.